A couple weeks ago I disassembled the front end to have the core support repaired. While it was apart I built my first set of spark plug wires and changed the plugs. I doubt I'll ever get a pre-made set again. So satisfying. The truck is back together, carburetor adjusted, still need to check/set the timing, and check/top-off the transmission and rear axle. Also adjusted the hood since the new core mounting pads and hardware changed dimensions enough to make the hood not want to close. Removed the latch to get the hood adjusted, then loosely bolted the latch back on to let it align itself on the stud, then tightened it all down. The front end sounds much more solid than it did before I took it apart. Tomorrow I can drive it again, and it will be going to get an alignment, the front right tire is wearing on the outside. Tire rotation is in order too.

Shane

Shane's Toys...
2007 Forester XT Limited (2nd Owner)
1991 Cherokee Laredo (2nd Owner)
1981 Chevy 3/4 Ton Fleetside 8,600 Camper Special (3rd Owner)
1965 Chevy 3/4 Ton Fleetside (3rd Owner)