October 2023

Fabricated and installed a vacuum reservoir behind the dash using an old propane cylinder. Mounted it just behind the speaker grille. I used hose clamps to secure it with a bolt thru each hose clamp and down thru the dash. Repaired headlight wiring harnesses and main wiring harness with period correct fabric covered wire. I had already added dual contact sockets to the parking lights so added wires for those, and for a 7-wire turn signal switch (turns out I didn‘t use that.)
Attachments
IMG_6329.JPG (192.97 KB, 157 downloads)
Vacuum reservoir fittings
IMG_6333.JPG (137.68 KB, 156 downloads)
Vacuum reservoir attached behind speaker grille
IMG_6339.JPG (366.02 KB, 154 downloads)
Headlight harness and cloth wrapped wire for repairs
IMG_6344.JPG (215.45 KB, 154 downloads)
Wiring diagram for 7-wire turn signal switch
IMG_6403.jpg (394.36 KB, 156 downloads)
Wire harness repairs with notations
IMG_6404.JPG (365.52 KB, 155 downloads)
Wire harness repairs with notations
IMG_6405.JPG (655.29 KB, 155 downloads)
Wire harness repairs with notations
IMG_6406.JPG (525.54 KB, 156 downloads)
Wire harness repairs with notations
IMG_6408.JPG (499.55 KB, 155 downloads)
The whole 9 yards
IMG_6410.JPG (601.53 KB, 156 downloads)
Reconstructed gas gauge sender harness


Kevin
1951 Chevy 3100 work truck
Follow this saga in Project Journal
Photos
1929 Ford pickup restored from the ground up. | 1929 Ford Special Coupe (First car)
Busting rust since the mid-60's
If you're smart enough to take it apart, you darn well better be smart enough to put it back together.