I have a milling attachment for my lathe. Clamps on to the compound and has a #2 Morse Taper collet in the head stock tightened by a hand wheel thru the spindle. Only has the travel of the cross slide and a few inches up and down. Limited but extremely useful.
In the photo, Iām enlarging the slots in a alternator bracket I bought online that were not big enough for the bolts that attach it to the block. I would love a Bridgeport but lack the room and the funds!
Last edited by Phak1; 11/26/202012:42 PM.
Phil Moderator, The Engine Shop, Interiors and Project Journals
1952 Chevrolet 3100, Three on the Tree, 4:11 torque tube Updated to: ā59 235 w/hydraulic lifters, 12v w/alternator, HEI, PCV and Power front Disc Brakes Project Journals Stovebolt Gallery Forum