The Stovebolt Site Forums Threads Created By Norcal Dave

Fixing the old truck

BUSY BOLTERS
Are you one?

The Shop Area

continues to pull in the most views on the Stovebolt. In August alone there were over 22,000 views in those 13 forums.

See what you're missing.

Searching the Site - a click away

New here ??? Where to start?

Click on image for the lowdown.

====

Who's Online Now

2 members (Truckrolet, klhansen), 494 guests, and 1 robot.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums66

Topics126,777

Posts1,039,268

Members48,100

Most Online2,175
Jul 21st, 2025

Step-by-step instructions for pictures in the forums

Threads Created \| All Posts Threads Created By Norcal Dave
Title	Forum	Post Time
261 crankshaft excessive end play & clutch judder- need help!	Driveline	07/07/2025 5:18 PM
261 crankshaft excessive end play & clutch judder- need help!	Engine Shop	07/07/2025 4:50 PM
Clutch judder insanity…	Driveline	01/07/2025 7:03 PM
700R4 trans w/ 261 ?	The HiPo Shop	09/20/2024 1:55 AM
Need help sorting out distributor on my 261....HEI	The HiPo Shop	03/08/2024 6:31 PM
Intake manifold heat..	The HiPo Shop	02/11/2024 2:25 PM
Diesel engine swaps?	The HiPo Shop	02/09/2024 11:44 AM
1950 Chevrolet 3600 3/4-ton pickup	1947 (2nd Series) - 1955 (1st Series)	02/02/2024 1:25 PM
Speedometer reading low even after speedo gear change	The HiPo Shop	02/02/2024 12:41 PM
Post your 261 pics!!	Engine Shop	01/20/2024 5:18 PM
What is the highway speed limit of a solid front axle?	The HiPo Shop	12/04/2023 12:59 AM
?? Carb rebuild kits for Langdon’s Carter/Weber dual carb conversion	The HiPo Shop	06/12/2023 3:28 PM
T5 swap- diaphragm clutch requires shorter TO bearing-taller pivot ball ???	Driveline	05/07/2023 3:41 AM
Issues with T5 swap- vibrations, etc᠁	Driveline	04/07/2023 2:35 PM
Front fender to cab gaskets?	Paint and Body Shop	08/16/2022 1:37 PM
Thanks for all the good advice here over the years᠁	Paint and Body Shop	07/17/2022 12:31 PM
Looking for ideas for a diamond-plate rear bumper	Paint and Body Shop	07/09/2022 12:58 AM
Bed wood finishing/oil	Making a Stovebolt Bed	07/02/2022 4:27 AM
Tool set & jack for under the drench seat?	The Tool Chest	06/23/2022 1:17 PM
Question about hood rear arch support & gap	Paint and Body Shop	06/17/2022 4:22 AM
Reverse (back-up) light- looking for something that looks right	The Electrical Bay	06/17/2022 1:34 AM
6 volt Horn with a 12 volt system?	The Electrical Bay	06/16/2022 2:22 AM
Looking for the Goldilocks Door Seal!	Doors	05/17/2022 12:32 AM
Cannot figure out how this piece attaches to the door!	Doors	05/08/2022 3:20 AM
Need help with door/cab weatherstrip	Doors	03/21/2022 5:39 AM
Pictures of Spanish grain vinyl bench seat?	Interiors	02/09/2018 6:21 PM
Cab & front end painted on color, bed & rear fenders painted black??	Paint and Body Shop	01/26/2018 6:49 AM
Need Help Identifying Rear Axle	Driveline	11/02/2017 5:12 PM
Correct location for parking brake release handle spring?	Driveline	08/21/2017 4:20 PM
I can't get my cab windlace on... ugh	Interiors	08/16/2017 1:17 AM
Should I lubricate the brush side of the horn contact?	The Electrical Bay	08/14/2017 5:44 PM
Does the ignition key barrel have a bezel?	Interiors	08/11/2017 4:29 AM
Bought a new wiring harness- no provision for Ammeter!	The Electrical Bay	07/22/2017 2:23 PM
Installation of Clutch & Brake pedal springs	Driveline	07/21/2017 3:23 AM
Questions about re-installing fuel tank & fuel lines	Engine Shop	07/16/2017 5:01 PM
Stomp starter bellcrank hitting the firewall	The Electrical Bay	07/16/2017 1:08 AM
Why you might want to consider checking the wiring behind your headlights	The Electrical Bay	07/11/2017 1:57 AM
Hood center strip question	Paint and Body Shop	07/09/2017 4:33 PM
Installing an electrical water temp sending unit	The Electrical Bay	07/09/2017 6:50 AM
New Post w/ pics RE: Delfleet SS Paint	Paint and Body Shop	07/07/2017 10:37 PM

Page 1 of 2