Thanks Dean -- so the throw out bearing conversion piece fits into the end of the actuator arm where the carbon disc is?

I have a shop manual on order.

Now for the next round of "Name That Part!"

... On the push rod covers ... am I right in thinking that the '27 didn't use side covers??
Attachments
20230518_170609.jpg (337.53 KB, 268 downloads)
What's this?
20230518_170703.jpg (497.4 KB, 268 downloads)
Are these cab parts?
20230518_170732.jpg (273.63 KB, 269 downloads)
Where do these go??
20230518_170755.jpg (304.67 KB, 268 downloads)
No clue ...
20230518_171044.jpg (355.69 KB, 267 downloads)
How do these attach if there is no bolt hole in the block?? Were mine filled in??
engine.jpg (168.83 KB, 269 downloads)
My engine. Can't see how the push rod covers attach??

~ John

A kid raised on Hotwheels, Matchbox and Tonka cannot be reasonably expected to own only one vehicle as an adult.

1949 Chevrolet 3804
In the Legacy Gallery | In the Gallery Forum
1973 IH 1310 Dump
1963 Kaiser M38A1
2001 International/AmTran RE3000 "Skoolie"
2014 Ford E-350 4x4 (Quigley)