Spent some time on the front fender. My BIL weded in the lower parch panel, I ground the weld down and added some filler. I am not a body man buy any means. This is just to get the patch filled, my friend Keefe is going to do all the finish work and blocking.

I found a couple of all pin holes.under the headlight bezel. I drilled the holes out and then welded them up. I ground the welds down and primed the area. I will strip the fender and coat it with epoxy primer later.
Attachments
IMG_2595.jpg (131.25 KB, 94 downloads)
Front fender patch
IMG_2596.jpg (143.83 KB, 95 downloads)
Pin holes

Last edited by TUTS 59; 01/10/2023 2:10 PM.
~ Craig
1958 Viking 4400
"The Book of Thor"
Read the story in the DITY
1960 Chevrolet C10
"A Family Heirloom"
Follow the story in the DITY Gallery
'59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)

If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane