Finally got a minute to take some measurements at the firewall. I should be able to move the engine back and use the existing holes for the mounts, that will put me about 1 1/4 inches from the firewall.

I may still need to modify the radiator mount to get the clearance needed at shroud. I was thinking about moving the mounts an inch back that would place the radiator in the stock location.

I also mounted the power steering pump.
Attachments
IMG_20210510_193129736.jpg (184.75 KB, 190 downloads)
Engine at firewall 1
IMG_20210510_193239670_HDR.jpg (262.54 KB, 194 downloads)
Engine at firewall 2
IMG_20210510_192028930.jpg (236.74 KB, 195 downloads)
Power Steering Pump 1
IMG_20210510_192045601_BURST000_COVER.jpg (241.76 KB, 192 downloads)
Power Steering Pump 2

~ Craig
1958 Viking 4400
"The Book of Thor"
Read the story in the DITY
1960 Chevrolet C10
"A Family Heirloom"
Follow the story in the DITY Gallery
'59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)

If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane