Worked a lot on the framing this weekend, set the front wall and started the area for the breezeway.

I have settled on building my own trusses, the lumber will be about $1800.00 and the labor free. I plan on using a jig for the layout to keep all the trusses uniform. I want to run them 24 in on center. As the only weight that will supported is the roof panels I think 2x4's will be more than sufficient to use for truss framing.

I have a lot yet to work out on measurements and angles for cuts. More head scratching.
Attachments
IMG_20220523_135615877_HDR~2.jpg (585.71 KB, 178 downloads)
Front wall set
IMG_20220523_135632388_HDR.jpg (399.86 KB, 177 downloads)
Breezeway Framing

~ Craig
1958 Viking 4400
"The Book of Thor"
Read the story in the DITY
1960 Chevrolet C10
"A Family Heirloom"
Follow the story in the DITY Gallery
'59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)

If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane