I made some progress on the rebar today. I set the rebar into slab 4 inches with epoxy. Once the epoxy has a chance to cure I will start settling the corner blocks.
I bought a Bosch SDS Hammer Drill from a pawnshop this week, using this to drill the holes for the rebar was like butter. I had priced a new Hammer Drill ($300.00 - $400.00) I thought I got a good price on this used one at $120.00, even had the case and a few bits.
Attachments
IMG_20220128_133440136_HDR.jpg (400.14 KB, 313 downloads)
Drilling holes
IMG_20220128_143431596_HDR.jpg (484.67 KB, 315 downloads)
Rebar set
IMG_20220128_143622207_HDR.jpg (420.45 KB, 313 downloads)
Hammer Drill

Last edited by TUTS 59; 01/28/2022 9:32 PM.
~ Craig
1958 Viking 4400
"The Book of Thor"
Read the story in the DITY
1960 Chevrolet C10
"A Family Heirloom"
Follow the story in the DITY Gallery
'59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)

If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane