progress... refurbishing the power/volume/tone switch
took it apart, cleaned all the bits, put a bit of fresh zinc onto some of the parts, re-assembled

the brass is stained because the oxidization reduced the alloy to just copper at the surface in some places
not sure the best way to make it look brass again, if i had a very fine wire brush i could probably polish until i'm at brass again
but it's in the bottom of the threads
suggestions?
-s
Attachments
Pwr_Vol_Tone_switch.jpg (86.23 KB, 207 downloads)
switch_repair.jpg (53.02 KB, 208 downloads)
switch_parts.jpg (132.94 KB, 207 downloads)
switch_done.jpg (102.84 KB, 203 downloads)