Sounds like your looking to spend a fair amount of change on a
table saw Jim. But if you you're not, and don't mind a little
restoration, as Alvin says, these old craftsman 10" saws were
well made. Cast iron tops and bullet proof cast iron adjustment.
This one I picked up about 35 years ago where it had been
stored in a shed out behind the tavern for a couple of decades
after Grandma Kunzer, my bartender's husband had passed away:
http://www.pbase.com/dennygraham/image/146942898 It's cut a lot of wood in those 35 years since I
restored it. Got it and a cast iron 18" Craftsman jig
saw out of that shed for twenty bucks. That old jig
saw was put to heavy use building wood wings for a
couple of airplanes back in the 70's and 80's.
Denny Graham
Sandwich, IL
