The Stovebolt Site Forums Threads Created By 57_StepSide

Labor Day

Labor Day

Putting down your wrenches or time for
MORE wrenching?
Wrenching this Labor Day

Plenty of places to share.

Searching the Site - a click away

New here ??? Where to start?

Click on image for the lowdown.

====

Who's Online Now

7 members (JW51, baldeagle, Dennys28, Bill Hanlon, Peggy M, Maybellene, Southerntruck), 62 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums66

Topics128,005

Posts1,055,264

Members48,418

Most Online14,466
Apr 26th, 2026

Step-by-step instructions for pictures in the forums

Brad Allen's photos

AD Chevy Trucks

Pictures galore

Over 6,000 pictures

Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips.

Check them out!

Lots of work on Brad's part ... pure enjoyment (and references) for you!

Big Thanks!

THANKS!

For helping keep this great
old truck web site
on the Internet for

over 30 years!

and not clogged down
with Ads!

Again, thanks!

Threads Created \| All Posts Threads Created By 57_StepSide
Title	Forum	Post Time
rust around headlight repair	Paint and Body Shop	05/02/2014 5:35 AM
Spraying Rustoleum	Paint and Body Shop	04/29/2014 3:37 PM
Percent gloss for frame and underhood parts	Paint and Body Shop	04/25/2014 11:18 PM
Anyone Re-rivet '57 grill?	Paint and Body Shop	04/07/2014 5:44 PM
Pin Hole Gas Tank Leak	General Truck Talk	04/18/2013 9:40 AM
recommendations for clicker type torque wrench	The Tool Chest	11/22/2012 1:10 AM
Bolter with 2.8L crankshaft?	Engine Shop	08/28/2011 6:13 PM
3 speed won't shift	Driveline	04/16/2011 7:28 AM
LED headlamps-Not head lights	The Tool Chest	01/25/2010 6:17 AM
Removing 235 manifolds for Painting	Engine Shop	01/15/2010 3:20 AM
Power Shears	The Tool Chest	12/30/2009 6:24 AM
Low Cost Cordless Drill	The Tool Chest	12/30/2009 6:01 AM
Buy this engine or not?	Engine Shop	12/12/2009 1:04 PM
Runs without Key	General Truck Talk	08/20/2009 1:10 AM
Stop switch failure	General Truck Talk	08/17/2009 3:38 AM
Points	The Electrical Bay	04/16/2009 5:07 PM
Jig saw spitting out blades	The Tool Chest	02/22/2009 9:27 PM
235 fan belt width question	Engine Shop	01/27/2009 5:52 AM
Fan Spacer on TF 235?	Engine Shop	11/21/2008 2:49 AM
'57 235 ci water pump pulley	Engine Shop	11/06/2008 12:17 AM
HF Coupon	The Tool Chest	09/20/2008 9:12 PM
New House, New Shop	The Tool Chest	07/07/2008 5:03 AM
Garage Drain Issue	The Tool Chest	06/09/2008 4:17 PM
What pressure washer do I need?	The Tool Chest	06/09/2008 4:14 PM
3 Phase Power to my residence	The Tool Chest	05/20/2008 8:47 PM
Using Lye to remove paint?	Paint and Body Shop	02/28/2008 2:49 AM
Compressor in same area as painting?	Paint and Body Shop	02/09/2008 4:01 AM
Sad Soda Blast Story	Paint and Body Shop	12/30/2007 7:03 PM
Question on electrolysis & need container suggestions	General Truck Talk	12/26/2007 11:53 PM
Small Kerosene or Propane Portable heater?	The Tool Chest	11/30/2007 5:18 PM
Need Advice on used set of regulators/torches	The Tool Chest	11/27/2007 5:00 PM
Wheel Dollys	The Tool Chest	11/22/2007 1:32 AM
Front Discs/Rear Drum - But Power or Manual?	The HiPo Shop	11/18/2007 4:44 AM
Cheap Clutch Head Sockets	The Tool Chest	08/15/2007 5:13 AM
Quality of Re-pop 2nd series Doors?	General Truck Talk	07/15/2007 6:39 PM
Looking for Experience with RE-POP TF Doors	Doors	07/15/2007 6:38 PM
Help-High Spot from Hell	Paint and Body Shop	07/15/2007 12:50 AM
drilling a frame rail	The HiPo Shop	07/03/2007 12:01 AM
Drilling a frame rail	General Truck Talk	07/03/2007 12:00 AM
90 Ohm Sending units with stock gauges	The HiPo Shop	06/13/2007 5:05 AM

Page 1 of 2