Scott, will be glad to take a few shots but right now it's unfinished. The A doors overlap the body about a 1/2", kinda like shingles on a roof. We used the door as a guide and cut around it with a plasma torch which gave 3/16 clearance for door gap. Then a 1/2x1/2 angle formed from 18g cold roll was migged in. I went to the Metro Molded catalog (
http://metrommp.com/) ph 800-878-2237, and clicked onto "extrusions". I think I will use the 1/2x1/2 seal that has the flap sticking off of one corner, much like door seals in the 50's & 60's. Like all from scratch projects everything is in flux and adjustments necessary but, that looks good right now. Will snap a pic and put it on my photobucket site with the "as is" progress.
