Good afternoon! Sometime I have to walk away and think. I jacked up the rear of the transmission. It did change the angle & I saw that the front end (edge) was only resting on the crossmember. I have the motor supported on the hoist. I guess it’s difficult to get bit strait so the shaft will slide out? I began removing floor panels. I don’t see how removing sections will help me get to that bolt. Most of the floor is solid. The part I removed did not get me a strait shot to the bolt, so that doesn’t help. I’m reverting back to thinking I need to remove the transmission, then the engine.
1953 Chevy 153A 3/4-ton Working on my project since 2015 Follow along in my DITY
