Not trying to hijack the thread, but since some of you seem to be knowledgeable in this area:

I would like to buy something absolutely turnkey (open the box, pull out the item, plug it in, and it works!) that:

(1) does not require water
(2) does not emit nasty fumes
(3) will cut Armstrong N-8090 1/16 inch (1/8 inch would be nice) from either an 8 1/2 x 11 or 11 x 17 sheet
(4) will either do its own scanning, or accept a file type I can get out of normal scanning software
(5) sells for less than $3500
(6) plugs into either 120v or 240v single phase
(7) and most importantly, does not require me to learn to use new software (remember the old dog - new tricks cliche)

Anyone know of anything that will fit the above description?

Jon

Good carburetion is fuelish hot air
The most expensive carburetor is the wrong one you attempt to modify.
If you truly believe "one size fits all," try walking a mile in your spouse's shoes!
The Carburetor Shop