I grab the wires/clips free without breaking them, but they are not going back on....no room

took a pic.

the tip of the screwdriver on the left side of the pic is up against the attachment point - like a flat metal round screw end.

looks like a screw that runs through a black plastic piece on the inside of the distributor and through a black plastic piece on the outside of the distributor - on the outside there was a nut.

I do not see anyway to loosen the inside of the bolt.

I found a set of points (forgot I had them) and will try them if I can get them attached.

[IMG]http://i1007.photobucket.com/albums/af191/hplacefb/IMG_0540.jpg[/IMG]

Last edited by hplacesbf; 07/09/2015 8:30 PM.