http://i175.photobucket.com/albums/w124/rockfan1815/engine-3.jpg unsure what amp link should be used for the wire from the alt to the power block and for the wire from the power block to the ignition switch.
i also redrew the diagram to show the battery in the stock battery box under the passenger floor.
im using the stock ignition setup, except for a msd blaster 2 ign coil
http://www.msdignition.com/coil_blaster_1_8200_8202_8223.htm it says to use the ballast resistor must be used for stock point ign setups.
