I have test fitted the sub body to the frame in order to fit up steering, throttle linkage, brake pedal, E-brake, gas filler,rear plywood floor, etc, etc. I am getting anxious to start the rebuilt 283. I need advice on temporarily wiring the engine to get it to run. It has been converted to HEI and it has a new Edelbrock carb. I think I have the distributor timed well enough to run. Can any of you bolters help me out with a diagram on how to get the engine wired? My intention is to buy a complete harness after the body is painted and installed on the frame permanently. Thanks guys and girls for the help.
Weeds
