The Stovebolt Site Forums The Shop Area Engine Shop Engine hoist completed...

Hi all...

I just got done building my engine hoist earlier today . Well, OK, it's not 100% done, it lacks the final touch of some primer and paint. You can see it here.

I used 3" x 3/16" square stock for the main parts and 2.5" x 3/16" square stock for the inner adjustable pieces, such as the leg extentions and extendable boom. All pins and reinforcing plates are stainless steel. The casters are industrial type (ball bearing swivel, neoprene wheels with a solid steel center hub) that I got for free . The whole unit was TIG welded using a Miller TIG outfit.

Take a peek...

Thanks, in advance!!!

Looks good may have to have you send me a copy of your blueprints.

Hi Burgie
Looks great. My hoist is basically the same, may be a bit heavier build, but I found that the vertical beam needs side support. You are only secured with those two bolts onto the lower x member.
I have a bolt just under the pivot point where I attache two flatbars down to the outside of the lower frame.

Check this link or go to my website and find the section attaching body to frame.
http://www.badmileage.com/Truck/Body_to_frame/Cab%20on%20Frame.JPG

I always try to have the bolts coming from the top down, should I loose a nut, there is always a bolt to keep the junk together.

I wish my welding would be as good as yours
Fritz