They are there if you choose to use them. Those pins, "in most cases" are about a little oversize. Read the tech tip on rebuilding these,John, and I think you use a 11/32 or a 13/32 bit to drill the holes out for the pins...not sure and as you know its always nice to check the ACTUAL size of the pins before you drill.

You can use the bushings but you'll have to drill the "tongue" piece out for them. I know this has been talked about and discussed but I can't find it.......yet. Remember, measure twice, drill once smile


EDIT: I think this is what your looking for.
http://www.stovebolt.com/techtips/doors/hinges%202013/

Last edited by Achipmunk; 05/22/2013 11:08 PM.
1937 Chevy Pickup
In the Gallery
1952 Chevy Panel
In the Gallery
More photos
1950 Chevy Coupe
Pictures!

I'd rather walk and carry a Chevy hub cap than ride in a Ferd.
I can explain it to you, but I can't understand it for you smile