The Stovebolt Site Forums The Shop Area The Electrical Bay 6V Coil No Resistor requirerd?

Ok it just keeps getting more confusing by the minute.

I'm having a heck of a time figuring out this wiring situation on my 59 with a 235, Alternator, Resistor and 6 volt coil.
If I didn’t have an alternator I would just set it up like it is in the shop manual. Or if I had a lot of cash I would put in a 12v coil and distributor.

So yesterday I bought a new coil and on the coil it says " 6V NO EXTERNAL RESISTOR REQUIRERD"
So does this mean I can run the coil directly to my Ignition (ING 1)? And if so what do I do with the ING 2.
Or do I just ignore the message and run the ING 1 wire to the Firewall Resistor and run the Coil wire to the Firewall Resistor and have the ING 2 wire tap into it like it is in the shop manual.

After this I have to figure out where to run the wire('s) from my Alternator to--?

Any help would be greatly appreciated. All I need to get this bad boy going on the road is the wiring problem resolved.