Originally Posted by APV60
1. existing 1406 eddy carb. Purchased carb feed line & filer. Inlet end on filter is -6 male AN. What AN fitting do I need to attach -6AN SS braided tubing to this?

Edelbrock/Carter carb to -6

http://www.summitracing.com/parts/AER-FBM2112

Then you would need something like this for the braided line to attach to it.

http://www.summitracing.com/parts/SUM-220687/

You would have to see exactly what degree fitting you would need depending on mounting requirements.


Originally Posted by APV60
2. Purchased Holley fuel pressure regulator. Both inlet and outlet are 3/8" NPT. What fittings do I use to attach -6 SS braided AN tubing to the 3/8" NPT outlet side of regulator?


Fitting, Straight, -6 AN Male to 3/8 in. NPT Male

http://www.summitracing.com/parts/AER-FBM2005/



Originally Posted by APV60
3.Inlet side of regulator is also 3/8". What fitting do I need to run -6AN SS tubing from inlet side of regulator to Holley fuel pump?

4.existing Holley fuel pump with 1/4"NPT. What fitting do I need to 90 out of pump and attach -6 AN SS tubing??Thank you.APV

I don't really know of a way to do this. You pretty much either have to run flare fittings for this or braided stainless, I've used the pushlock hose recently, it's pretty nice stuff.

Some people say I suffer from insanity, in reality, I enjoy every minute of it!