I helped my father maintain GMC tank wagons when I was in school. I owned trucks for 62 years and I finally auctioned them off earlier this year so I am back to tinkering with 70 year old iron. I always measured the big hole and if it was in spec, I reused it. GMC rods are between 2.4563 and 2.4568. I have measured a lot of rods from Cummins as well as GMC and Y-Block. I rejected very few rods. And in all those years I only had one 2 rods to go out the side of the block. Both were in trucks that I bought used that had engines built by a machine shop.