thanks for the replies! i had the rods resized and i'm just going to remove the bolts from some spar rods i have. i have rebuilt many engines in my life time. i had just assembled all the rod caps with new checked bearings on their specified rods. i grabbed the torque wrench and proceeded to tighten the nuts. 20# the first time through then to 45#. then i started at no.6 it bumped the torque up to 80#. for some unknown reason i thought i had read that the final rod torque was 80#. anyway the bolts stretched massively, its a wonder they didn't snap. i haven't checked maybe the threads were pulling out of the nut. i tried a couple more and got the same results and stopped and checked what was wrong. and found that they were to be 45#, so the rest are ok. thats my story and i'm not proud of it!!!!