This entry should finally close out this thread.

Finished my first full tank of gas today with an average of 13.55 MPG. grin That is about the same as this Carter YF 964S was getting the last time I rebuilt it 40,000 miles and about 12 years ago. It had recently dropped to around 6-7 MPG and would drain down overnight causing 5-6 seconds of cranking my 6 volt starter with a 12 volt battery before the first start of the day.

The two suspect 10-32 screws seem to be doing okay, with no apparent leaks down the side of the carb's body. If I notice leaking I have a 10-32 HeliCoil kit at the ready.

The only problem I still have is that the throttle doesn't want to completely close when I let off the gas pedal. It hangs at about 600 RPM (which is fine for A/C season) instead of dropping to the 425 RPM specified in the Maintenance Manual. If I just tap the gas pedal the engine drops to 425 RPM. I've removed the throttle linkage from the carb and tested. With the linkage unhooked the RPM drops like it should, so the carb isn't the problem, it's the linkage. Maybe a little squirt of lube.

My thanks to all of you who contributed to this thread. shake

Last edited by Bill Hanlon; 11/07/2026 11:13 PM.

'57 GMC 102, Original 347 V8, HydraMatic, 3.08 rear gear, added A/C, disk front brakes, HEI, AFB carb, '98 Honda Black Currant paint. T-boned and totaled 10/12
'52 GMC 152 Stake Bed, Original 228, SM420, added A/C, HEI, disk front brakes, '67 Chev 3.55 rear gear. Gets used as a real truck.