Winter is Coming
Time to think about winterizing your Bolt.
A good Tech Tip WINTERIZING YOUR TRUCK including a link back to the Forums for additional tips.
Thank you Dan- You are giving me a lot to think about, and all good advice! It sounds like my best bet would be the internal oil line behind the valve pushrod cover....? If I did that it would be out of sight and relatively easy to plumb in. (I attached another marked-up pic) Or do you think it would be best to use the outside port in the head?
This engine came from a running truck, but I can't figure out how the internals were in such good shape. I did replace the valves, but the rocker shaft etc. measured in tolerance etc..
Thanks again to everyone for the information! Dave
55 GMC 3100 2nd Series 71 GMC 1500 Super Custom 1956 Thriftmaster 1954 Blue Flame 1962 Thriftmaster