Thanks Gdads- I knew about the center head bolt, and no, I did not have that on this engine. All bolts were solid as removed. I can see the square-head plug just below the top center of the pushrod galley (see attached); it seems like the line would connect here, but this plug was in it as I received the engine. I also attached a view of the opposite side showing the tee that goes to the oil filter, and the open end that went to....? Again, this is how I received the engine. I have it set up on a start kart right now, so I can at least watch the oil flow to see if there is another oil passage that isn't visible??
Any suggestions are greatly appreciated! Thanks!
Attachments
square plug for-oil line.jpg (175.11 KB, 49 downloads)
tee-oil line.jpg (182.86 KB, 45 downloads)


55 GMC 3100 2nd Series
71 GMC 1500 Super Custom
1956 Thriftmaster
1954 Blue Flame
1962 Thriftmaster