Thank you Dan- You are giving me a lot to think about, and all good advice! It sounds like my best bet would be the internal oil line behind the valve pushrod cover....? If I did that it would be out of sight and relatively easy to plumb in. (I attached another marked-up pic) Or do you think it would be best to use the outside port in the head?

This engine came from a running truck, but I can't figure out how the internals were in such good shape. I did replace the valves, but the rocker shaft etc. measured in tolerance etc..

Thanks again to everyone for the information!
Dave
Attachments
draw-in oil line.jpg (175.07 KB, 33 downloads)


55 GMC 3100 2nd Series
71 GMC 1500 Super Custom
1956 Thriftmaster
1954 Blue Flame
1962 Thriftmaster