I tried to fabricate a bracket to hold the return springs, but later found out I needed to install the engine side pan that holds the Z bracket for the brake return spring and wire extension. My setup now looks like this which I believe is stock. Same spring is used for the brake and clutch. Are there other pictures you need?
Attachments
IMG_1775a.jpg (144.92 KB, 157 downloads)
IMG_9609a.jpg (116.38 KB, 152 downloads)
IMG_9610a.JPG (102.49 KB, 152 downloads)
IMG_9644a.jpg (74.87 KB, 152 downloads)
IMG_9808b.jpg (119.56 KB, 149 downloads)

Last edited by UtahYork; 03/13/2026 7:39 PM. Reason: Spelling
~ John in Utah
1946 1/2Ton w/4-speed manual transmission w/1960 235 engine
Here We Go
Follow in his DITY Bay

- If you think about it, it has been one year ago today!