| |
Click on image for the lowdown. 
====
| | |
1 members (Southerntruck),
134
guests, and
0
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,192 Posts1,057,353 Members48,469 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Aug 2007 Posts: 31 Wrench Fetcher | | Wrench Fetcher Joined: Aug 2007 Posts: 31 | I don't have new seals on bottom of door's of my 52 to make a gestimate and see where they strike rocker panel. My doors are nice and level with rocker and have right gaps front and back. Should bottom of door be even with bottom of rocker or hang below just a bit? I understand there is probably not an exact measurement here and this might vary from truck to truck. Thanks in advance.
Doug | | | | | Joined: Sep 2007 Posts: 2,644 Shop Shark | | Shop Shark Joined: Sep 2007 Posts: 2,644 | If your doors have a good gap along the top, front and rear and align with the beltline the position in relation to the sill or rocker panel is good. I believe there are pictures of where to install the bottom seals in the Factory Assembly Manual. | | | | | Joined: Oct 2009 Posts: 83 Wrench Fetcher | | Wrench Fetcher Joined: Oct 2009 Posts: 83 | Nowadays there is a spec. for gaps between doors, hoods, fenders, quater panels; usually just a few MMs. BAck then I beleaive it was "an equal-distance" all around, which is what everybody uses anyway.
1999 GMC Yukon
1957 GMC 100 Panel
| | |
|
|
| |
