| |
BUSY BOLTERS Are you one?  The Shop Area
continues to pull in the most views on the Stovebolt. In August alone there were over 22,000 views in those 13 forums.
| | Click on image for the lowdown. 
====
| | |
3 members (68ironhead, JW51, 1 invisible),
574
guests, and
2
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics126,776 Posts1,039,271 Members48,100 | | Most Online2,175
Jul 21st, 2025 | | | | Joined: Mar 2000 Posts: 137 'Bolter | | 'Bolter Joined: Mar 2000 Posts: 137 | i cant find any info on replacing my oil lines on my 59 gmc 270 motor! most of my lines are brittle or cracked ! where can some be purchased ? i thought somebody on this site had a article ? i also need a picture of the bottom side of the front motor mount,does it use a plate/ washers or ? w std nuts or a locking nut or? thanks mike | | | | | Joined: Mar 2006 Posts: 319 Shop Shark | | Shop Shark Joined: Mar 2006 Posts: 319 | The 55-59 GMC Truck Maintenance Manual which is online at the Keith Hardy site has a cutaway drawing of the front mount of the 270 on page 361 of the engine section. http://chevy.tocmp.com/gmc/5559mm/index.html
"Nothing astonishes men so much as common sense and plain dealing." - Ralph Waldo Emerson
| | | | | Joined: Jan 2007 Posts: 81 Wrench Fetcher | | Wrench Fetcher Joined: Jan 2007 Posts: 81 | I carried my old lines and fittings to a W W Grainger store not far from me. They asked what pressure I needed. I suggested 60 psi. The supplied a 5000 psi hydraulic line (the 5000 is not a typo) with appropriate fittings to accomodate each end of both lines. Don't remember the cost, but was very reasoneable.
meansam | | |
|
|
| |
