| |
Click on image for the lowdown. 
====
|
| | Forums66 Topics128,050 Posts1,055,757 Members48,426 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
|
| THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
|
| | | Joined: Nov 2005 Posts: 67 Wrench Fetcher | | Wrench Fetcher Joined: Nov 2005 Posts: 67 | Hello, I have several small pin holes under the back window, on the outside, above were the two panels meet. I'm considering the options of what method of repair would be best. The paint shop up the road told me i'd be better off cutting out the entire strip and replace with new metal. But there is only a few holes and i can see that lead filling on the rest of my truck has lasted the best So i'm more inclined to try that. Then spray some rust perventative to inhibit any more holes. however it is a sealed panel. So i'm going to drill a hole behind were the seat would be and install a rubber gromet when i'm finished. What do you guys think? (before i start)
Brendon | | | | | Joined: Mar 2002 Posts: 990 Member | | Member Joined: Mar 2002 Posts: 990 | problem is that when you start working on that stuff, I bet the holes open up and you get more of em. Usually the metal has gone paper thin when you see that stuff. | | |
|
|
| |
