Click on image for the lowdown. 
====
| | |
13 members (Gray_Ghost, FAST55, 1955 1 Series, GusG, Bill Hanlon, sron48, Wally / Montana, Stovebolt48, JW51, GrandpasJimmy, tclederman, ‘37ChevyPU, 1 invisible),
71
guests, and
3
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,185 Posts1,057,281 Members48,467 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Oct 2015 Posts: 7 New Guy | | New Guy Joined: Oct 2015 Posts: 7 | So I parked my 66 C60 about 2 months ago for some motor work. Completed the motor work today and hopped in to take it for a spin and the clutch pedal went all the way to the floor and didn't return. Checked the fluid in the master and it was low so topped it off. Still no pedal. Nothing is moving at the slave. Any tips thoughts comments or help will be appreciated. | | | | | Joined: Jun 2011 Posts: 5,096 Crusing in the Passing Lane | | Crusing in the Passing Lane Joined: Jun 2011 Posts: 5,096 | Hydraulic leak somewhere in line or at slave. Rubber in master could be collapsed or rotted. Since you are in the rust belt, may as well replace all rubber parts, clean w/ alcohol, not spirits, gas or diesel.
Ed
Last edited by EdPruss; 01/04/2016 3:42 AM.
'37 GMC T-18 w/ DD 4-53T, RTO-610, 6231 aux., '95 GMC running gear, full disc brakes, power steering, 22.5 wheels and tires.
'47 GMC 1 ton w/ 302, NP-540, 4wd, full width Blazer front axle.
'54 GMC 630 w/ 503 gasser, 5 speed, ex fire truck, shortened WB 4', install 8' bed.
'55 GMC 370 w/270, 420 4 speed, grain, dump bed truck from ND. Works OK.
| | | | | Joined: May 2005 Posts: 8,878 . | | . Joined: May 2005 Posts: 8,878 | Sounds like a leak. You cold try bleeding the system, there is a bleeder screw on the slave cylinder same as on a wheel cylinder. That might get it operating until it leaks enough out again. | | | | | Joined: Jan 2008 Posts: 4,963 'Bolter | | 'Bolter Joined: Jan 2008 Posts: 4,963 | Back when I drove a cabover with a hydraulic clutch, I made a power bleeder by drilling a hole in the cap and putting in a valve stem. I used a bicycle pump for pressure. It is almost impossible to bleed a hydraulic clutch without pressure | | |
|
|
