| |
Click on image for the lowdown. 
====
| | |
7 members (NJC, baldeagle, Gray_Ghost, Peggy M, Wickedbass, Charles in CA, cmayna),
77
guests, and
7
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,018 Posts1,055,342 Members48,419 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: May 2011 Posts: 8 New Guy | | New Guy Joined: May 2011 Posts: 8 | Hey everyone, I have been reading about carbs for a few days now and I need some advice on my float drop. I rebuilt my Rochester BC and adjusted the float to the rebuild spec measurements. When the car runs now it has been leaking out of picture A. After driving about 10 miles it was puking gas out of a hole in picture B. I think that my float drop is too low and letting too much fuel into the carb does this make sense? I’m new to carbs guys but I’ve been reading a lot about them. Picture A http://imageshack.us/photo/my-images/43/img00100201105171902.jpg/Picture B http://imageshack.us/photo/my-images/856/img00102201105171902.jpg/
Last edited by ZMi; 07/09/2011 5:15 PM. Reason: clarity
| | |
|
|
| |
