Have had new stainless steel upper and lower control arms supplied by TCI on the bench for quite a while. Decided to install the arms after getting dropped stubs from speedway motors. The install went OK with assistance from my older son Rhys. However the last item to be installed was the TCI sway bay. This did not fit as it is too wide for the mounts supplied. In changing the arms from painted to stainless it reduced my wheel track by 1 inch either side. No mention of any issues with this upgrade on their web site. I have sent photos over to TCI and the response was to shorten and retap the bar to suit the mounts. So if you are looking to use a TCI mustang 11 with polished control arms DO NOT buy a swaybar because guess what IT NO FIT. Emailed TCI with a string of questions and no response. I suggested they set a mustang 11 up on the bench and see that they supply parts that do not fit > no response. I read lower down in another post there are questions about suppliers of front end kits in regard to TCI they are off my xmas card list
End result
TCI does not supply a sway bar to fit their front end with their control arms without the purchaser doing major changes. After spending $$ with this firm it ain't good enough
Buyer beware

1950 Chevrolet 3100 in Oz