Had some more time to look at the 235 in my Dad's 3100, and it looks like our guess was correct. It would appear that one of the halves of a split bearing rode up on the other, locking the crank in place, and causing this truck to have not been run for the past 18 years! Has anyone else run into this before? How can I fix the situation. Here's a few pics for you.
First off, we have the front half bearing compared to the half that the oil sump bolts onto (that one is the third from the front).
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_1993.jpg
Next up, you can see where the bearing race is no longer connected to the thing (more technical term?):
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_1995.jpg
Here you see the split bearing still hanging onto the crankshaft, even after having to pry the other bit off...
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_2000.jpg
Is it normal for this bearing to have lips on both sides? It seems that this wedged it in the crank:
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_2001.jpg
The backside of the bearing (you're not usually supposed to see this!):
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_2006.jpg
The part of the bearing that the crank actually rests on:
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_2007.jpg
If you look closely, you can see that the top half of the bearing has spun slightly and is hanging out of its channel. Attempts to tap it back in were unsuccessful...:
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_2011.jpg
A cleaner shot of the above:
http://www.king-nerd.com/dood/images/minigal/1953%20Chevy%20project%20truck/3.%20Tearing%20down%20some%20of%20the%20engine,%205-08-06/thumbs/tn_med_100_2012.jpg
Any thoughts on how hard this situation is going to be to rectify? My dad wants to keep the truck original, but I'd rather modernize it a little... At this point, it looks like we'd have to tear the entire engine down for a cleaning anyway...