My truck was built from 3 or 4 donor trucks to make one good one. The kid I bought it from did a pretty good job, but the body panels don't fit as nicely as it should. For example, my hood is close to the driver's side fender, but too far from the passenger side fender. The adjustment rods in the engine bay help that a little, but not enough. In fact, the frame appears to not be straight either. My guess is it needs the frame straightened, and then the panels might end up fitting a lot better.
Are there any other adjustments besides the rods inside the engine bay though that I could try?
The truck is a 1952 GMC 3/4 Ton Long Bed. Thanks.
