| |
Click on image for the lowdown. 
====
| | |
0 members (),
179
guests, and
1
robot. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,299 Posts1,058,705 Members48,493 | | Most Online14,466 Apr 26th, 2026 | | AD Chevy Trucks Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down with Ads! Again, thanks! | | | | Joined: May 2015 Posts: 11,292 Housekeeping (Moderator) Making a Stovebolt Bed & Paint and Body Shop Forums | | Housekeeping (Moderator) Making a Stovebolt Bed & Paint and Body Shop Forums Joined: May 2015 Posts: 11,292 | Lowering the rear won't really affect the u-joint much. It will reduce the angle. You don't want it completely straight (although that may only apply to u-joints with needle bearing cups) but it'll probably be a couple degrees. You should loosen the pivot bolts on the spring mounts until you have it setting where you want it and then tighten those to normalize the rubber bushings in them. Can't really say about the front axle short of new flatter springs if you're using the stock axle.
Kevin 1951 Chevy 3100 work truckFollow this saga in Project JournalPhotos 1929 Ford pickup restored from the ground up. | 1929 Ford Special Coupe (First car) Busting rust since the mid-60's If you're smart enough to take it apart, you darn well better be smart enough to put it back together. | | |
| |
| |