I’ve got the burlap on& a sticky back thin carpet over that. The 2 inch foam looks too thick to allow the back rest to move over it.
Should I order 1 inch or just not attempt to put the foam under the back?
I could split (thin it out) it at the back seat? The outside end higher than the center section.
Just adding that I did remove the back seat, trimmed the foam thinner.
The cover sure has a lot of excess material in the back, if I have it turned correctly (front to back)?
Attachments
IMG_4745.jpeg (512.69 KB, 62 downloads)
IMG_4747.jpeg (241.95 KB, 61 downloads)
image.jpg (239.82 KB, 61 downloads)
image.jpg (307.13 KB, 61 downloads)
image.jpg (228.61 KB, 55 downloads)
image.jpg (172.19 KB, 54 downloads)

Last edited by glennj3; 12/12/2025 8:05 PM.
1953 Chevy 153A 3/4-ton
Working on my project since 2015
Follow along in my DITY