vonkluver, Are you talking about using an early cast iron Powerglide with the torque tube output??? I don't think the mounting pattern on one of those will match up to the 230 as that has the same bell housing pattern as the V8. The 230 Powerglide would be an open drive output requiring a different open drive rear axle. Not sure how you would mate the existing torque tube to the non-torque tube Powerglide???

If you are going to use the 230 and Powerglide, just go full open drive rear end and your cost will be much smaller than trying to do the adpation. smile


~ Dan
1951 Chevy 3 window 3100
Follow this story in the DITY Gallery
"My Grandpa Carl's Truck and How it Became Mine"
1966 Chevelle (Wife's Hot Rod) | 2013 Chevy Silverado (Current daily driver)
US Army MSG Retired (1977-1998) | Com Fac Maint Lead Tech Retired (1998-2021)