[b][/b]
I'm about to begin the bed installation on my 1950 1 ton, 9ft bed
I ordered the kit
Truck has 4 cross sills plus the rear cross sill
Each sill requires blocks and pads and the rear cross sill just pads
The kit came with 6- 1/2" pre drilled blocks and 6 pads
I need two more 1/2 pre drilled block and pads for the fourth cross sill
I also got with the kit 6- 3/8 pre drilled blocks and
10 pads in an another bag
Than oddly enough only 10 - 3/8 ×6" long carriage bolts with offset washers
Do I even need the second kit with the smaller pre drilled holes
I'm thinking about robbing a couple and drilling them out for the cross sills or am I going to need them somewhere else?
