I did this on my 49’ and use it for a full width middle seat
I used 1” metal tube and conduit bender

Originally Posted by windyville1
I just picked up a 47 truck seat that I want to weld the bottom tubes on and use it for my rear seat in my 50 burb.

1. Is there anybody out there that reproduces these seats that would sell me the
three bent tubes so I can weld them on myself.

2. If I have to make these tubes, what is the measurement of the space between floor and seat frame on an original seat.

Thanks fellas.
Originally Posted by windyville1
I just picked up a 47 truck seat that I want to weld the bottom tubes on and use it for my rear seat in my 50 burb.

1. Is there anybody out there that reproduces these seats that would sell me the
three bent tubes so I can weld them on myself.

2. If I have to make these tubes, what is the measurement of the space between floor and seat frame on an original seat.

Thanks fellas.
Originally Posted by windyville1
I just picked up a 47 truck seat that I want to weld the bottom tubes on and use it for my rear seat in my 50 burb.

1. Is there anybody out there that reproduces these seats that would sell me the
three bent tubes so I can weld them on myself.

2. If I have to make these tubes, what is the measurement of the space between floor and seat frame on an original seat.

Thanks fellas.
Originally Posted by windyville1
I just picked up a 47 truck seat that I want to weld the bottom tubes on and use it for my rear seat in my 50 burb.

1. Is there anybody out there that reproduces these seats that would sell me the
three bent tubes so I can weld them on myself.

2. If I have to make these tubes, what is the measurement of the space between floor and seat frame on an original seat.

Thanks fellas.

1949 Chevrolet 3100 Suburban Carryall
"Bad Guy"
In the Stovebolt Gallery
More pix in Photobucket

1950 Chevrolet 3100 3-Window
In the Stovebolt Gallery
More pix on Photobucket

1966 GMC Suburban Carryall Custom
"Big Guy"
In the Stovebolt Gallery
More pix on Photobucket