Hello All,
I am preparing to do the 4:11 to 3:55 swap. I have the whole, Patrick's Ring & Pinion kit. Including all of the bearings, shims and gaskets. While I wait for the weather outside in Arizona cool down, still over a 100 here everyday. Will be working in my garage. Nearly that warm out there. I the meantime, I am trying to gather up all the tools that I am going to need for the conversion. The only thing that I don't have, are the Carrier Bearing Adjusting Wrenches. Where did you guys that have done the conversion, get your Adjusting Wrenches? Or, did you make do with something else. Say, a screwdriver and a hammer. I think I would prefer to use the correct tools for the job. Any advice and or direction, would be greatly appreciated.
Thanks,
Rugo
