Hi folks...

so I have a set of clutch head drives now that fit my 3/8 drive ratchet, very handy.

For anyone that may come in here in the future, there is a square bolt on the inside of the cross member that you will have to hold to get it loose.

Now my problem is this, the line in question is the one that runs along the backside of the cross member that goes under the transmission between the frame rails... and it goes into the back of the master cylinder :

brake line - back of master cylinder

Now, I had my brake line wrench on there and tried the righty-tightey, lefty loosey action, but it didn't budge. Is there a trick to getting it off? I sprayed some pb blaster on there and I will try later but thought I'd come in and ask some other folks for tips and tricks.


also, added some more brake line photos to the folder here, same the one linked in the original post :

album of 1953 Chevrolet 3100 Series - brake line photos

Thanks.

-Woog