I am getting it all summed up from all the good advice above.......thank you very much

I need a Signal Stat turn Signal

I need a inline flasher relay

I need two front turn signal lights

I need a fuse block to mount under the dash for the buss fuses and relay flasher

I need dual filaments for my two tail lights I have now which is stock 1939 Chevy Sedan tail lights


I will need some 12 gu stranded wire ,,will measure after figuring out the runs to the lights ,ect ect

My 39 is changed over to 12 volt

______________________________________________________

I was thinking of running the wires down the out side of the steering wheel and to the fuse block and then on to thru the floor board to the motor area and then on to the 4 different lights .. any thoughts on doing this? I already have a sleave that has wires in it that runs from down the stearing post support to the floor.

I want small turn signal lights for the front ,I would mount them to the front bumper braces..Or ? got any favorites to share with me? again any thoughts appreciated

Directions are just another man's Opinion