I used a cheap one on my 64 but it only worked, like it was supposed to, on the larger areas of sheet metal. The metal is just too tough back then to pull dents close to a bend or a seam. Maybe a better welder will do heavier guage sheet metal,
Scott

Scott Ward

2 1948 1.5-ton Loadmasters
The red one and The snow pusher
1 1950 3100
1 1955.1 Chevy 6500
1 1954 Chevy 6500 2-Ton
1 1955 1st Series COE 5700
1 1963 K20 (454)
1 1964 C10 (350)
1 1951 1.5-ton Dump Truck
1953 and a 1956 Ford F800

Raising a teenager is like trying to nail Jello to a tree!