The Stovebolt Site Forums The Shop Area The Tool Chest junk engine stands from Maxtool California

Bought a new engine stand from the above vendor, I wanted a good one not tippy and well rated, (2000lbs)
put a 235 on it and it dropped over like a wet noodle, the motor plate on it is less than .230" thick, this is a total
Chinese POS buyers beware!
Shipping is too high to send it back so making my own motor plate and bolt brackets, don't trust these pieces of crap at all!

I make my own and prefer the engine cradle design with four wheels .I use the engine hoist if its to low in the cradle to work on.