| |
Click on image for the lowdown. 
====
| | | Forums66 Topics128,166 Posts1,057,092 Members48,463 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | 
#44410 11/22/2002 7:51 PM | Joined: Nov 2002 Posts: 48 Wrench Fetcher | | Wrench Fetcher Joined: Nov 2002 Posts: 48 | I am currently getting ready to install a 350 small block in my 53 3100 and was wondering what is the easiest way to hook the clutch pedal assembly up to the modern V-8 bellhousing I am using a 1973 1/2ton donner truck and will be using the toploader sm465 Muncie truck 4speed from that truck I know my 53 doesn't have a Z bar assembly has anyone done this conversion with a mannual tranny? I asume I will have to use the 73' bellhousingand starter, unless anyone knows of a conversion kit so I can use my stock 53 bellhousing and starter? I want to retain the pedal operated start button as well and the only way I know to do that with the modern syleniod starter is the use of a electrical pressure switch mounted to the proper firewall location
Does anyone know where I could buy a adapter plate so I could use my stock stovebolt bellhousing? I know they make Auto tranny adapters for the stovebolt 6 but I want to go the other dirrection ie.. V-8 4speed however I want to maintain a totally stock apearance in the cab and exterior of the truck, Just don't lift the hood! Thanks for any advice in advance! This is by far the best site I have found so far!
PS: my 216 engine, bellhousing, tranny, starter, torque tube rear end, and shaft go on the swap meet this weekend!!!
If you need a tool and don't buy it, you will find you have paid for it and don't have it.
| | |
#44411 11/22/2002 8:07 PM | Joined: Jul 2001 Posts: 19 Junior Member | | Junior Member Joined: Jul 2001 Posts: 19 | Zach,
I'm doing about the same thing. I'm putting a 283 in a '50. The bell housing that was on the 283 had a hydraulic clutch with the clutch fork(?) on the passenger side. That won't work. I had a bell housing out of a '67 Chevy with the clutch fork on the driver's side that was in the same location as the 216's bell housing. However, when I cleaned the bell housing, I found that the bell housing is cracked so I need to find another one. What is the configuration of the bell housing that you have? Where is the clutch fork located?
Brad | | |
#44412 11/22/2002 10:42 PM | Joined: Oct 2001 Posts: 3,458 Extreme Gabster | | Extreme Gabster Joined: Oct 2001 Posts: 3,458 | The bellhousing off a manual tranny Chevy 250 from about '67 or so will fit your V-8 and some of them have non hydro clutches, I just got rid of one. It had a four speed hooked to it, too.
Paint & Body Shop moderator
A lone amateur built the Ark. A large group of professionals built the Titanic. | | |
|
|
| |
