| |
Click on image for the lowdown. 
====
| | | Forums66 Topics128,022 Posts1,055,373 Members48,420 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Jul 2004 Posts: 5,708 'Bolter | | 'Bolter Joined: Jul 2004 Posts: 5,708 | Kyle,
To do it properly the spindles would have to be replaced. To do a makeshift fix until you replaced them you can use a sharp punch to bring up a bunch of little 'berries' on the worn portion of the spindle. This will help hold the inner race from turning.
With the punch marks and some quality Loctite retaining compound, the fix will probably last a very long time.
Stuart | | | | | Joined: Jan 2008 Posts: 4,960 'Bolter | | 'Bolter Joined: Jan 2008 Posts: 4,960 | For casual driving, you can peck around the bearing journal with a center punch until you get a good fit with the bearing. If the bearing gets too tight, you can dress it down with a hand grinder until you get a fit. This was a very common practice with even 18 wheelers until about 25 years ago. It will probably last as long as you own the vehicle. The idea is to get it so you can get the bearing on, but tight enough to keep the bearing from turning on the spindle. If the bearing turns on the spindle, it will generate heat and cause premature bearing failure, but by pecking and dressing the spindle and with today's lubricants, you should be fine for a long time. | | |
|
|
| |
