| |
Click on image for the lowdown. 
====
| | | Forums66 Topics128,139 Posts1,056,756 Members48,454 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | 
#25481 03/12/2002 10:16 PM | Joined: Feb 2002 Posts: 7 Member | | Member Joined: Feb 2002 Posts: 7 | I reassembled the U-joint, then realized I forgot to pre-stage the
gaskets and seals on the drive shaft! SO I have to take it apart
again. While I am cursing my forgetfulness, I realize that I have a
cork seal that is needed in the Bell assembly of the Torque tube, but
don't know where it goes. There was only the one gasket spacer on the
unit holding everything closed (even though the manual says to start
with four) The manual says to preassemble the bell for a certain
check, but not with the cork seal installed.
My question is: Where the heck does the cork seal go anyway? I can't
seem to find anyplace it is needed.
Mike
51 3100 | | |
#25482 03/13/2002 8:33 AM | Joined: Jun 2000 Posts: 2,773 'Bolter | | 'Bolter Joined: Jun 2000 Posts: 2,773 | Cork seal goes between the ball and the collar. Installation is described in the transmission section of your shop manual. If you don't have a shop manual, they are well worth the $25-30.
Fred
52 3600
69 C-10
| | |
|
|
| |
